Remove the brake drums.
Disconnect the handbrake cable from the balance lever and remove it from the brake disc.
Remove the rods from the forks and the fasteners from the tension equalizer of both cable rods.
Disconnect the cable from the hand lever and remove it.
The handbrake cable is installed in the following order.
Attach the cable to the hand lever. Pass the cable through the brake disc and attach it to the balancing levers. Attach the cable sheath to the brake shields.
Attach the cable tension equalizer to the front cable.
Install and secure the brake drums.
Adjust the handbrake. To do this, loosen the handbrake lever and press the main brake pedal. The shoes will then be set in their original position.
Adjust the length of the cable so that the control pins can be moved by 0.5-2 mm (Fig. 6.10).
Install the rear wheels and lower the car to the ground.