Contents: Removal ↳ Installation ↳
Removal
1. Remove the clamps and unscrew the 4 bolts securing the stabilizer to the body.
2. Unscrew the nuts securing the stabilizer to the lower wishbones, remove the front metal washers and front rubber rings (see Fig. Front suspension).
3. Unscrew the nut on both sides of the suspension mounting bolt of the control arm to the engine mount crossmember.
4. Move the levers away from the body and remove the stabilizer, remove the rear rubber rings and rear metal washers from the stabilizer.
Installation
Install the anti-roll bar by performing the steps in the reverse order of removal. The nuts securing the suspension arms to the engine mount crossmember should be tightened in two stages (see Fig. subsection 9.1.1) only by lowering the car.