Contents: Removal ↳ Installation ↳
Removal
1. Remove the inner door trim.
2. Carefully remove the sealing film around the door handle and rods.
3. Unscrew the two screws (13) (see Fig. Door closing mechanism), tilt the bottom part away from the door and detach the top part from the door.
4. Raise the rods (12) (see Fig. Door closing mechanism) and remove it from the door frame.
5. Disconnect the inner door handle rod from the rear of the door handle, and then the lock release rod.
6. Remove the door handle.
Installation
Installation is performed in the reverse order of removal. Particular attention should be paid to gluing the sealing film, since if the film is not glued tightly, drafts may occur in the car interior.