Contents: Removal ↳ Installation ↳
Removal
Disconnect the negative (-) battery cable.
Caution: When the battery is disconnected, the contents of electronic memory devices, such as engine fault codes or radio codes, are erased. Before disconnecting, also read the instructions in the chapter "Removal and installation the battery".
Remove the rubber seal of the air chamber from the front wall.
Unfasten the electric cable from the cover. The cable is secured in three places "B".
Unscrew the fastening screws "A" and remove the cover from the front wall.
Disconnect both plug connectors "B" of the additional resistors.
Unscrew the 2 mounting bolts "A" and remove the fan housing assembly.
Remove both top halves of the housing.
Disconnect additional resistors "C" from tension band "B". Release the tension band and remove the fan motor.
Installation
Insert the fan motor into the lower half of the housing and secure with tension strap.
Attach additional resistance to the tension band. Install both upper halves of the housing on the lower half of the housing.
Install the fan housing assembly into the vehicle and secure it.
Connect both plug connectors of the additional resistors.
Place the lid on the front wall and screw it on.
Secure the electrical cable to the lid.
Place the rubber seal on the front wall.
Connect the battery ground (-) cable.
If available, set the clock and enter the radio theft protection code.
For more information, please visit the website FORDBOOK.RU