Replacing the rear brake disc (Scorpio 1)

Removal

1. Loosen the nuts securing the corresponding rear wheel.

2. Raise the car and remove the wheel.

3. Disconnect the handbrake cable from the bracket on the rear suspension arm.

4. Unscrew the two caliper mounting bolts.

5. Suspend the caliper under the car using soft wire, being careful not to damage the brake hoses.

6. Mark the position of the disc relative to the wheel hub.

7. Remove the brake disc spring retaining ring.

8. Remove the brake disc.

Installation

1. Install the brake disc in relation to the wheel hub in accordance with the markings made during removal, and put on the spring mounting ring.

2. Secure the caliper.

3. Hook the handbrake cable to the bracket on the rear suspension arm.

4. Install the wheel and lower the vehicle.

5. Tighten the wheel nuts to the required torque.

6. Press the brake pedal several times to bring the brake pads into contact with the brake disc.

(The original can be found on this resource: www.FordBook.ru)