1. Move the seat all the way back, then unscrew the two bolts securing the front part of the seat (one of the bolts is indicated by the arrow).
2. Disconnect the assist spring from under the driver's seat (moving the seat forward will relieve tension on the spring, but will make it more difficult to access).
3. Disconnect the seat heater and seat adjustment motor connectors.
 |
 |
4. Move the seat forward as far as it will go and unscrew the three bolts. These bolts are covered with a plug (indicated by the arrow in Figure 1) and a cover (indicated by the arrow in Figure 2).
5. Remove the seat together with the seat adjustment mechanism and seat belt buckle.
6. Installation is carried out in the reverse order of removal.
Removal and installation the front seat airbag
1. Remove the front seat.
2. Remove the side trim from the seat. Remove the air tube by unscrewing the two mounting screws.
3. Separate the backrest from the seat base by unscrewing the four bolts.
4. Remove the backrest upholstery by bending back the retaining tabs and pulling it off.
5. Remove the foam pad. Cut the wire loops securing the corners of the cushion and remove it along with the air hoses.
6. Installation is performed in the reverse order of removal. In this case, it is necessary to use new wire rings.
7. Install the slots in the cushion level with the second spring in the back.