The right support of the power unit suspension is a non-separable unit consisting of a collar 1 and a rubber cushion 2. The support cushion is attached with two nuts to the bracket on the engine cylinder block, and the collar is attached with two bolts to the body side member.
You will need: a 15 mm socket head and an 18 mm wrench.
1. Remove the expansion tank from the brackets on the body (see "Removing and installing the expansion tank") and move it to the side without disconnecting the hoses.
2. Place a secure support under the engine or lift it using a lifting mechanism.
3. Unscrew the two nuts securing the support to the engine cylinder block bracket…
4. …unscrew the two bolts securing the support to the body side member and remove the support.
5. Install the right powertrain mount in the reverse order of removal.
NOTE: Pay attention to the marking on the support. Purchase a new support with the same marking.
(The full article is on the online resource: «FORDBOOK.ru»)