Fig. 5.11. Right support of the power unit suspension: 1 – nut for fastening the support of the power unit suspension to the engine cylinder block bracket; 2 – Engine cylinder block bracket; 3 – bolt for fastening to the body side member; 4 – right support of the power unit suspension.
You will need: a 15 mm socket head and an 18 mm wrench.
The right support of the power unit suspension is a non-separable unit. The support is attached with two nuts 1 (Fig. 5.11) to the bracket 2 on the engine cylinder block and with two bolts 3 to the body side member.
1. Remove the decorative engine cover (see Removing and installing the decorative engine cover).
2. Place a secure support under the engine or lift it using a lifting mechanism.
3. Unscrew the two nuts 1 securing the support to the engine cylinder block bracket.
4. Unscrew the two bolts 3 securing the support to the body side member.
5. Remove support 4.
6. Install the right powertrain suspension support in the reverse order of removal.
(Information for this article was taken from the website FORDBOOK.ru)