Name | Specification |
rear panel |
Withdrawal
1. General note
- Remove the following: bumper, luggage compartment floor, spare wheel cover, rear exhaust muffler and skid plates.
2. Remove the back panel section
- 1. Mill out the spot welds (to a depth equal to twice the thickness of the panel).
- 2. Place of cut.
- 3. Mill out the spot welds using an abrasive wheel.
Installation
1. Sectional rear panel replacement
- 1. Ream existing holes to 5mm (to a depth equal to the thickness of the panel) and puddling.
- 2. Perform a puddling weld.
- 3. Perform MIG welding.
Visitor comments