Checking for misalignment of the lower part of the body (bottom)

1.

NOTE: Underbody inspection and service procedures are specified. Measurements can be made using the SHARK electronic measuring system, laser measuring system, or other equivalent system.

When repairing serious damage to the body, it is necessary to restore the dimensions of the lower part of the body. This is necessary to ensure the correct installation angles of the front and rear wheels. For information on the correct underbody dimensions, refer to the figure "Underbody Dimensions". All dimensions are tied to the centers of the holes in the lower part of the body (on the bottom). After checking the unikuz and suspension mounting points, other prescribed operations can be performed regarding the lower part of the body.

Adjustment

1.

NOTE: Tolerance: ±3mm.

Underbody dimensions (dimensions of the lower part of the body)

• Detailed illustrations show the left side of the vehicle.
• All measurements are taken with the units removed.

3. Valid for 3- and 5-door variants



5. Valid for 3- and 5-door variants




7. Valid for 4-door variants



9. Valid for 4-door variants



11. Valid for station wagon versions



13. Valid for station wagon versions.