Front seat belt retractor mechanism (Focus 1)

Removal

4-door version, 5-door version and "Station wagon"

1. Disconnect the lower seat belt anchor element.



3-door version

2. Disconnect the lower seat belt anchor element.

• 1. Remove the hex bolt from the mounting element rail.
• 2. Remove the seat belt from the fastening element rail.

All cars

3. Disconnect the upper B-pillar trim panel.

NOTE: Some factory trim panels have a retaining clip installed on the leading edge.

• 1. Disconnect the mounting clamps.
• 2. Remove the bolt and washer from the lower seat belt webbing (4-door, 5-door and Estate shown).
• 3. Route the seat belt webbing through the upper B-pillar trim panel.

4. Disconnect the upper seat belt anchor element.





4-door version, 5-door version and "Station wagon"

5. Remove the lower B-pillar trim panel.



3-door version

6.

NOTE: Screws are located behind the seat back and under the seat cushion.

Remove the lower trim panel.

• 1. Remove the bottom screw.
• 2. Remove the top screw.
• 3. Disconnect the front clamps.
• 4. Disconnect the upper clamps.

All cars



7. Detach the belt guide loop.

• 1. Pull the belt guide loop back.
• 2. Pull the belt guide loop down.
• 3. Detach the belt guide loop.

8. Remove the seat belt retractor mechanism.

• 1. Remove the bolt.
• 2. Lift and remove the retraction mechanism from the locking tab.

Installation

1.

CAUTION: Make sure the spacer is positioned correctly between the floor mat and the inside of the door sill.

CAUTION: Make sure the pin on the B-pillar trim is correctly positioned in the height adjustment mechanism.

CAUTION: Before tightening the hex bolt, make sure that the rear end of the mounting rail (3-door version) is positioned correctly.

To install, follow the removal procedure in reverse order.