Contents: Removal ↳ Installation ↳
Removal
1. Place the vehicle over an inspection pit or lift it on a lift.
2. Remove the clutch release fork housing from the clutch housing after removing the spring hook.
3. Move the ratchet stopper away from the gear sector by inserting a suitable wooden block under the clutch pedal.
4. Disconnect the end of the cable from the clutch release forks by moving the end down and then forward.
5. Remove the left part of the upholstery near the pedals.
6. Disconnect the cable from the pedal with the toothed sector and move it through the hole between the pedal and the toothed sector.
7. Pull the cable through the opening in the front bulkhead into the engine compartment.
Installation
1. Insert the cable through the hole in the front bulkhead from the engine compartment side, pass it between the clutch pedal and the toothed sector and hook its end on this sector.
2. Pull the cable forward to remove it from the sheath and hook the other end onto the clutch release forks.
3. Secure the rubber boot together with the spring hook to the clutch housing.
4. Remove the wooden block from under the clutch pedal.
5. Install the previously removed trim around the pedals back in place.
6. Lower the car.