Replacing the front wheel speed sensor
1. Loosen the nuts securing the corresponding front wheel.
2. Raise the car and remove the wheel.
3. Unscrew the rotation sensor mounting bolts.
4. Disconnect the electrical connector from the rotation sensor.
5. Remove the sensor.
6. Disconnect the sensor wire from the spring clips.
7. Clean the wheel speed sensor mounting socket from dirt, traces of rust, etc.
8. Lightly lubricate the sensor mounting socket with bearing grease.
9. Install a new O-ring onto the sensor.
10. Install the speed sensor into its socket.
11. Tighten the sensor mounting bolt.
12. Connect the electrical connector to the sensor and hook the electrical wire into the spring clips.
13. Install the wheel and lower the vehicle.
14. Tighten the wheel nuts to the specified torque.
Replacing the rear wheel speed sensor
Caution! The brake fluid in the rear brake circuit is under high pressure. Do not press the brake pedal.
1. Loosen the nuts securing the corresponding rear wheel.
2. Raise the car and remove the wheel.
3. Release the handbrake lever.
4. Raise the rear seat and tilt the floor covering forward.
5. Remove the wire from the bracket and disconnect the electrical connector from the wheel speed sensor.
6. Disconnect the handbrake cable from the bracket on the rear suspension arm.
7. Remove the front brake caliper mounting bolt.
8. Turn the caliper upward.
9. Unscrew the sensor mounting bolt and remove it.
10. Clean the wheel speed sensor mounting socket from dirt, traces of rust, etc.
11. Lightly lubricate the sensor mounting socket with bearing grease.
12. Install a new O-ring onto the sensor.
13. Perform the same initial steps as for installing the front wheel speed sensor, and then perform the steps in reverse order as for removing the rear wheel speed sensor.
Other information regarding the technical characteristics, adjustment and repair of the brake system is given in section 10 and in subsection 3.1.3.20.
The original article can be viewed on the portal (FORDBOOK)