1 - Shock absorber strut dome (wheel housing)
2 - Upper stop of the shock absorber strut. The stop is attached to the body with two bolts. The molded part of the stop precisely matches the corresponding bed of the wheel arch and holds the shock absorber strut in a strictly defined position
3 - Shock absorber strut
4 - Magnetic valve for adaptation of the suspension system
5 - Rear axle suspension cross beam
6 - Eccentric bolt/washer. For track adjustment.
7 - Anti-roll bar, 25 Nm. Tighten the bolts only with the vehicle standing on its wheels
8 - Connecting element, 35 Nm. For fixing the stabilizer
9 - Front wishbone
10 - Rear wishbone
11 - Axle journal
12 - ABS wheel sensor, 10 Nm
13 - Reactive rod
14 - Brake caliper
15 - Upper spring plate
16 - Compression buffer. The buffer limits the travel of the shock absorber spring during compression. During expansion, the spring travel is limited by an internal stop
17 - Conical coil spring
18 - Shock absorber piston rod seal
19 - Shock absorber
20 - Terminal bolt, 85 Nm. For lower shock absorber strut mounting
21 - Bolt, 85 Nm. When tightening, the car must stand on its wheels
22 - Nut, 35 Nm. When tightening, the car must stand on its wheels
23 - Bolt, 120 Nm. When tightening, the car must stand on its wheels
24 - Bolt, 120 Nm. When tightening, the car must stand on its wheels