1. Disconnect the wire from the negative terminal of the battery.
2. Remove the decorative engine cover (see Removing and installing the decorative engine cover).
3. Disconnect the high-voltage wires from the ignition coil terminals.
4. Squeeze the latch…
5….and disconnect the low-voltage wire harness connector from the ignition coil.
6. Remove the four ignition coil mounting screws…
7….and remove the coil.
NOTE: Pay attention to the markings on the ignition coil. For replacement, purchase a coil with exactly the same markings.
8. Install the ignition coil and all previously removed parts in reverse order. To correctly connect the high-voltage wires to the ignition coil, you will find the numbers of the corresponding engine cylinders next to the terminals on the coil housing.
NOTE: Before installation, lubricate the high-voltage wire terminals with a grease such as petroleum jelly.