Removing the master brake cylinder expansion tank (Mondeo 3)

ORDER OF EXECUTION

Disconnect the main fluid level sensor connector and...
...and unscrew the shut-off cap from the tank. Once removed, do not turn it over. This may damage the electrical contacts.
Suck out the brake fluid from the expansion tank using a pipette or syringe.
Carefully remove the empty reservoir from the master cylinder by hand.
Before installing the new reservoir, insert new sealing rings into the master cylinder bores. Lightly moisten these rings with fresh brake fluid beforehand.
Carefully press the new tank into the sealing rings. The tank should audibly lock into place. Then pour in the fluid.
Screw on the locking cap and check the operation of the warning light switch by pressing on the elastic middle of the cap.
Bleed the brake system.

Working together: two brake pistons work in tandem with the master brake cylinder.
1 — Brake circuit pusher,
2 — "Floating" main brake circuit,
3 - Primary cuffs,
4 - Separate cuffs.

(For more information, please visit the website FORDBOOK)

Article reviewed: Herman Ostrovsky

« Previous articles
Replacing brake fluid
Bleeding the brake system
Checking the wear of the disc brake mechanism
Measuring the wear of disc brake pads
Checking the brakes for functionality

Next articles »
Removal and installation of the master brake cylinder
Dismantling and installation of the brake booster
Removing and installing brake hoses
Replacing disc brake pads
Replacing brake discs