Contents: Checking oil pressure (engine… ↳ Checking oil pressure (engine… ↳ Measuring oil pressure (1.8L Endura… ↳
Oil pressure depends on various factors (engine crankshaft speed, oil temperature, oil viscosity, degree of contamination of the oil filter, etc.).
NOTE: Measure the oil pressure at the specified engine speed. Measure the oil pressure at an oil temperature of 80°C.
Checking oil pressure (engine 1.4/1.6 Zetec - SE)
1. Raise and support the vehicle.
2. Disconnect the oil pressure switch connector and remove the oil pressure switch.
3. Connect the pressure gauge with the appropriate pressure gauge mounting adapter and position it so that the reading can be read from above.
4. Lower the vehicle.
5. Check the oil pressure.
6. Raise and secure the vehicle.
7. Disconnect the oil pressure gauge and adapter.
8. Apply oil pressure switch sealant (WSK-M2G349-A7) to the oil pressure switch.
9. Install the oil pressure switch and connect the oil pressure switch plug connector.
10. Lower the vehicle.
Checking oil pressure (engine 1.8/2.0 Zetec - E)
1. Raise and support the vehicle.
2. Disconnect the oil pressure switch connector and remove the oil pressure switch.
3. Connect the pressure gauge with the appropriate pressure gauge mounting adapter and position it so that the reading can be read from above.
4. Lower the vehicle.
5. Check the oil pressure.
6. Raise and support the vehicle.
7. Disconnect the oil pressure gauge and adapter.
8. Apply oil pressure switch sealant (WSK-M2G349-A7) to the oil pressure switch.
9. Install the oil pressure switch and connect the oil pressure switch plug connector.
10. Lower the vehicle.
Measuring oil pressure (1.8L Endura DI and Duratorq TDCi engine)
1. Remove the top engine cover.
2. Remove the positive crankcase ventilation (PCV) housing.
3. Disconnect the oil pressure switch connector.
4. Remove the oil pressure switch.
5. Connect the oil pressure gauge to the pressure gauge adapter.
Note: Measure the oil pressure at an idle speed of the crankshaft and at 2000 rpm.
6. Check the oil pressure.
7. Disconnect the oil pressure gauge and oil pressure gauge adapter.
8. Install the oil pressure switch.
9. Connect the oil pressure switch plug connector.
10. Install the PCV housing.
11. Install the top engine cover.
The original can be found on this resource: fordbook.ru