Checking the position of the roof hatch

1.

NOTE: The sunroof must be in the closed position to perform adjustments.

Remove the sunroof guide arm covers (if equipped).



2. Place a suitable plastic spacer, 1.0-1.2mm thick and 150mm long, between the rear edge of the sunroof glass and the sunroof opening.

3. Adjust the rear edge of the sunroof glass.

• 1. Loosen the mounting screws.
• 2. Push the trailing edge up or down to align the position correctly (level to + 1mm).

4. Make sure the sunroof glass is centered in the sunroof opening.

5. Tighten the rear mounting screws.



6. Adjust the front edge of the sunroof glass.

• 1. Push the front edge up or down to align the position correctly (level to - 1mm).
• 2. Tighten the front mounting screws.

7. Install the sunroof guide arm covers (if equipped).



8.

NOTE: Remove the plastic spacer.

Operate the sunroof and check for proper alignment.

9. Check the sunroof seal, paying attention to wind noise and water leaks.