Filling the cooling system and removing air

Attention! Air is removed from the cooling system automatically after the engine is started.

1. Screw in the coolant drain plugs in the cylinder block and radiator.

2. Check the fastening of the elastic pipes of the cooling system.

3. Fill the system with coolant through the filler hole of the expansion tank to the level marked "MAX" on the tank and screw on the cap.

4. Start the engine and keep its speed between 1000-1500 rpm until the cooling system thermostat opens.

5. Check the fluid level in the expansion tank, which should be between the signs "MIN" And "MAX"