Removal and installation front wheel arch trim (Scorpio II) (Scorpio 2)

Removal

Mark the position of the front wheel on the hub with paint. This will allow the balanced wheel to be installed again in its previous position. When loosening the wheel mounting nuts, the car must be on the platform. Raise the front of the car onto the support jacks and remove the front wheel.



Remove bolts "1". Remove slotted head bolts "2".

Drill out rivet "3".

Remove the wheel arch trim.

Installation

Place the wheel trim on and screw it on.

Using standard rivet pliers, install a new rivet "3".

Place the front wheel so that the marks made before removal match. First apply a thin layer of plastic grease for rolling bearings to the place where the rim fits on the wheel hub. Do not lubricate the threads of the wheel studs. Tighten the wheel with nuts. Lower the car and tighten the wheel mounting nuts crosswise to a torque of 100 Nm.


[Content was created using data from this website: www.FordBook.ru]