Contents: Removal ↳ Installation ↳
Removal
Disconnect the negative (-) cable from the battery.
Warning! This will erase data in electronic memory devices, such as the engine fault memory device or the radio code. Please read the section carefully "Removing and installing the battery", before disconnecting it.
Remove the outside door handle.
Insert the key into the lock.
Unlock the lock core by carefully pulling the spring lock core stopper towards you with a small screwdriver.
Turn the key in the lock and remove the core from the lock slot.
Installation
Insert the core into the door handle and press lightly until it locks into place. Make sure the groove on the core matches the groove on the handle and the drive lever.
Pull out the key.
Install the outside door handle.
Connect the ground (-) wire to the battery terminal.
Set the time on the clock.
Set the radio anti-theft code.
The original can be found on this resource [FORDBOOK]