- loosen the wheel nuts;
- Raise the rear of the car on supports and remove the wheel;
- release the car with the parking brake;
- disconnect the wear indicator wire (loosen the bolt, disconnect the connector);
- unscrew the brake hose from the brake pipe, close the ends properly to prevent contamination from entering;
- remove the brake pads as described in the previous subsection;
Fig. 265. Location of brake caliper mounting bolts
- loosen the caliper mounting bolts (Fig. 265); there are protective caps on the bolts, which should be removed first;
Fig. 266. Disconnecting the brake caliper from its support
- remove the parking brake cable from the lever and, as shown in Fig. 266, disconnect the caliper.
Install in the reverse order of removal. Tighten the caliper support mounting bolts to 41 N·m. Make sure that the brake hose does not rotate when connecting. Reinstall the protective caps on the bolts. Be sure to bleed the brake system.
The text is available on the specified website info portal: FordBook.ru