Removal and installation the stabilizer (Scorpio 1)

Removal

1. Remove the clamps and unscrew the 4 bolts securing the stabilizer to the body.

2. Raise the front of the car and unscrew the nuts securing the stabilizer to the lower wishbones, remove the front metal washers and front metal-rubber bushings.

3. Unscrew the nut on both sides of the suspension mounting bolt of the control arm to the engine mount crossmember.

4. Move the levers away from the body and remove the stabilizer, remove the rear rubber rings and rear metal-rubber bushings from the stabilizer.

Installation

1. Install the suspension stabilizer by performing the actions in the reverse order in relation to the removal process.

2. The nuts securing the suspension arms to the engine mount crossmember should only be tightened after the vehicle has been lowered.


The text of the article was copied from the website FORDBOOK