Rear Suspension Strut Repair (Sedan and Hatchback) (Mondeo 1 and 2)

1. The procedure is performed in the same way as the repair of the front suspension strut (paragraph 5). Note that the spring compressors must remain on the spring after the removal procedure (see Fig. 12.1.a-d).

(This article was borrowed from the website: Fordbook.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Yaroslav Gorbunov

« Previous articles
Removing and installing the rear suspension strut (Sedan and Hatchback)
Removing and installing the rear suspension axle support (Sedan and Hatchback)
Inspection and replacement of the rear hub and bearings (Sedan and Hatchback)
Replacing the ball joint of the lower arm of the front suspension
Removal, repair and installation of the lower arm of the front suspension

Next articles »
Rear Anti-Roll Bar (Sedan and Hatchback)
Lower Rear Suspension Arms (Sedan and Hatchback)
Removing and installing the torque arm (Sedan and Hatchback)
Removing and installing the rear suspension beam (Sedan and Hatchback)
Inspection and replacement of rear hub and bearings (Station wagon)