1. Open the trunk.
2. Remove the floor mat…
3. …unscrew the spare wheel holder…
4. …and take it off.
5. Remove the spare wheel well cover…
6. …take out the spare tire…
7. …and remove the jack from the holder.
Note: Install the jack paw into the special sockets located on the body sills near each wheel.
Note: The jack is supplied with a sticker containing instructions for its use.
8. Place the jack under the body threshold so that the edge of the threshold is located in the groove of the jack head.
Attention! Before lifting the wheel, engage 1st gear, brake the car with the parking brake and place chocks under the wheels on the opposite side.
Warning! Do not work under a vehicle raised on a jack, but if you cannot do without it, install strong and stable supports under the axle.
(Information for this article was taken from the website www.FordBook.ru)