1. Disconnect the supply line from the brake master cylinder nipple (see "Replacing the clutch release master cylinder").
2. Squeeze the plastic clips (for clarity, this operation is shown on the removed brake master cylinder reservoir)…
3. …and remove the supply hose from the fitting.
4. Install the feed hose and all previously removed parts in the reverse order of removal.
To replace the clutch slave cylinder line do the following.
1. Disconnect the clutch slave cylinder line tip from the clutch master cylinder nipple (see "Replacing the clutch release master cylinder").
2. Unscrew the bolt securing the clutch housing ground wire terminal…
3. …and move the wire to the side.
4. Pry up the clamp securing the pipe end retainer, remove the clamp…
5. …and remove the pipe tip from the clutch slave cylinder nipple.
6. Disengage the clutch slave cylinder line from the retainer and remove the line from the vehicle.
7. Install the clutch slave cylinder line in the reverse order of removal.
(This article is a copy from the website: FORDBOOK.ru)