Removing and installing the watch (Mondeo 1 and 2)

Removal

1. Disconnect the negative battery cable.

2. Use a small screwdriver to push the watch away from the front panel, placing a rag under the screwdriver to avoid damaging the front panel (see Fig. 13.2).

3. Disconnect the electrical connector on the back of the watch and remove the watch (see Fig. 13.3).

Installation

4. Installation - in the reverse order of removal. Set the clock parameters.

The original article can be viewed on the portal [FORDBOOK.RU]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Yaroslav Gorbunov

« Previous articles
Removing and installing the speedometer drive cable
Removing and installing instrument panel components
Removing and installing the instrument panel
Removing and installing the headlight tilt motor
Headlight beam adjustment

Next articles »
Removing and installing the horn
Removing and installing windshield wiper arms
Windshield wiper motor and drive mechanism
Rear Door Wiper Motor Assembly
Additional vehicle parameter monitoring system