A-pillar
The A-pillar is the front pillar of the car body on which the front door is hung.
Before removing, pull the door seal in the trim area.
Detach the trim from the upper and lower clamps "1".
Pull the trim up "2" and remove the lower sealing strip.
Remove the upper and lower holders from the stand.
Attach both brackets to the trim before installation.
Insert the alarm and antenna wires into the holders.
Install the seal and secure the trim with the holders on the A-pillar.
Slide the door seal over.
B-stand
The B-pillar is the middle pillar of the body on which the rear door is suspended.
Before removing, pull the door seal in the trim area.
Remove the trim from the holders.
Use a screwdriver to separate the top and bottom trim.
Remove the front seat belt fastening under the front seat.
Remove the trim and feed the seat belt through the trim.
Pull the seat belt through the trim and tighten to a torque of 40 Nm.
Connect the top and bottom trim.
Fix the trim in the holders and slide on the door seal.
C-pillar
The C-pillar is the rear pillar of the car body.
Before removing, pull the door seal in the trim area.
Pull up and remove the seat cushion.
Tilt the rear seat back forward.
Remove the trim by removing the plugs, unscrewing the screws "1" and releasing the clamps.
Unscrew the lower rear seat belt anchor and pull the belt through the trim.
Pull the seat belt through the trim and tighten to a torque of 40 Nm.
Fix the trim with clamps and fasten with screws. Insert plugs.
Raise the rear seat back and lock it.
Install the rear seat cushions and press down.
Slide the door seal over.
C-stand (Turnier)
Remove the upper rear seat belt fastening.
Release the trim from the clamps and remove.
Tighten the belt to a torque of 40 Nm.
Install and secure the trim with clamps.