Removal
Use a thin nylon cord to cut the adhesive bond between the mirror base and the black surface of the windshield.
Remove the mirror.
Installation
Caution: Do not touch the black surface "A" on the windshield "B" and the bonding surface on the mirror "C", otherwise perfect bonding will not be ensured.
Installing a removed mirror
Clean the mirror leg from old glue with a lint-free cloth and alcohol. Allow the alcohol to dry for about 1 minute.
Attention! The mirror base must be perfectly clean.
Remove the protective film from one side of the adhesive layer and press the adhesive layer firmly onto the mirror base.
Clean the black surface on the windshield.
Attention! For perfect adhesion, the glass should not be too cold. Before gluing, the car should be at least 1 hour at an ambient temperature of about 20°C.
Heat the mirror leg and adhesive film with a hair dryer for 30 seconds to a temperature of 50-70°C.
Remove the protective film from the other side of the adhesive layer.
Attention! If the mirror is installed on a new windshield, first remove the protective film from the black surface of the windshield.
Place the mirror base exactly on the black surface of the windshield, press firmly and hold for at least two minutes.
After 30 minutes, check the installation and operation of the mirror.