Interior equipment (Transit 2)

            0

Front ashtray



Front ashtray


To remove the ashtray, press the spring clip and pull it out.

Rear ashtrays



Rear ashtrays


Press on the side and the ashtray will come out of the slot freely. To remove the ashtray, press the spring clip.

Cigarette lighter



Cigarette lighter


To use the cigarette lighter, press it and wait until it pops out automatically.

The cigarette lighter socket can be used as a power source with an output voltage of 12 V and a maximum current of 10 A.

Warning! Never hold the cigarette lighter button down, as this can cause a fire. Always remove it as a precaution if children are left alone in the car.


Glove compartment



Glove compartment


To open it, press the latch on both sides.

Interior rearview mirror



Interior rearview mirror


To reduce the brightness of the reflection at night, tilt the mirror down by pressing the lever.

Interior lighting with reading lamp



Interior lighting with reading lamp


The interior lighting is located above the rearview mirror and has a three-position switch: door switch, on and off
  • Interior lighting.
  • Footrest lighting.

The lamp lights up and goes out automatically when the sliding door is opened and closed.
  • Overhead lighting.

The lamps are controlled by a switch, their direction can be changed in the desired direction.

Front door windows



Front door windows


They are controlled by turning the window lift handle.

Side windows



To open the window, press the button and slide it to one of three positions along the window opening.

Rear windows



Rear windows


To open the windows, pull the lock lever toward you, then outward and back until the window is secured. You can choose three positions: open the window completely, partially, and close. To close the window, turn the lever inward and press it.

Door mirror



Door mirror


Adjust the position of the mirror by simply turning it on the lever. If necessary, the entire mirror assembly can be turned towards the window.

Removable partition



Removable partition


The removable partition is attached to metal posts in the body.

Warning! After installing the partition, make sure the metal supports are covered to prevent injury.


Front seat


  • How to extend/retract seats.

To adjust the seat position, pull the lever up.

To adjust the seat position, pull the lever up.

  • Changing the height of the driver's seat.

To raise or lower the seat, pull the lever located in front of the seat.

To raise or lower the seat, pull the lever located in front of the seat.


Adjusting the seat back angle



The angle of the front seat can be adjusted by turning the handle located on the right or left side of the seat.

The angle of the front seat can be adjusted by turning the handle located on the right or left side…


Adjusting the curvature of the seat back.

The backrest curvature can be adjusted using a hand pump. Press the button to decrease the bend.

The backrest curvature can be adjusted using a hand pump. Press the button to decrease the bend.


Front passenger seat



The front seat can be folded forward using a lever on the outside of the base of the seat.

The front seat can be folded forward using a lever on the outside of the base of the seat.


Warning: After returning the seat to the upright position, make sure it is securely latched; you should hear a click when it locks into place.


Heated front seats (single seats)



Heated front seats (single seats)


The seat cushion and backrest heating switch is located on the inside of each seat. The switches have built-in indicator lights. The maximum temperature is reached in 5-6 minutes and is thermostatically controlled.

Rear seats



Rear seats


The seats can be removed by unscrewing the retaining bolts. When reinstalling the seats, make sure that the threaded holes in the floor and the holes in the seat frames align. Then install the retaining bolts and tighten them to the required torque.

Headrests



Headrests


The headrests can be adjusted in height and angle manually. They can be completely removed by pressing the locking button on the right headrest pillar.

Warning: Adjust the headrest so that it is behind your head, not behind your neck.


Warning: Adjust the headrest so that it is behind your head, not behind your neck.


The luggage compartment can be increased by folding the rear seat forward.

The luggage compartment can be increased by folding the rear seat forward.


Remove the headrests. Pull up on the button on the top of the rear seatback and tilt the seatback forward.

Remove the headrests. Pull up on the button on the top of the rear seatback and tilt the seatback…


Pull back the handle at the base of the seat and tilt the entire seat forward.

The seat support legs can be folded by pressing the handle to the right.

Warning: When reclining the seat back to its normal position, make sure the base is firmly seated in the mounting points, which should be accompanied by a clicking sound.


Front seat tilt



Front seat tilt


You can get into the rear of the car through the front passenger door by tilting the front passenger seat forward. This can be done by pulling up the locking button on the back.

Warning: When returning the seatback to its original position, make sure it snaps into place and clicks into place.


Seat belts



Seat belts


Seat belts must be used by everyone. Only one person can use one belt. For children, you can purchase special seats at the Service Center. The belt must not be twisted or pinched by the passenger or cargo.

The belts provide maximum protection with the backrest in a nearly vertical position.

Transportation of children



Children should be transported in child seats or on child booster cushions with adult seat belts. For these additions, please contact the Service Center.

Use of automatic three-point seat belts.

Gradually pull the belt out of the reel. The belt will lock if you pull it sharply.

Warning: Insert the tongue into the lock until it clicks. Only after this is the seat belt properly fastened. The waist belt should be positioned low on the hips, not across the stomach.


To unfasten the belt, press the red button on the buckle. Make sure the belt is completely retracted back into the reel.

To unfasten the belt, press the red button on the buckle. Make sure the belt is completely…


Changing the height of the front seat belt attachment point



Changing the height of the front seat belt attachment point


By adjusting the strap's attachment point, you can position it more comfortably, as close to the middle of your shoulder as possible, for maximum comfort.

Automatic rear seat belts



Fasten your seat belt and secure it. You should hear a click. The belt should be positioned on your hip.

Seat belt maintenance



Check seat belts periodically for damage and wear. Check the reliability of the attachment points and the locking of the inertia reels, sharply pull each strap.

Warning! Do not attempt to repair, lubricate the reel mechanism, or modify the belts in any way.


Belts deformed as a result of an accident are replaced and tested at the Service Center.

Cleaning seat belts



Use Motorcraft Upholstery Cleaner or clean water. Rinse and let dry naturally away from artificial heat.

Use Motorcraft Upholstery Cleaner or clean water. Rinse and let dry naturally away from artificial…


The original version can be found on the website: FordBook.ru






Link to this page in different formats


Visitor comments

No comments yet



We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪