Contents: Removal ↳ Installation ↳
Removal
Disconnect the negative (-) cable from the battery.
Warning! This will erase data in electronic memory devices, such as the engine fault memory device or the radio code. Please read the section carefully "Removing and installing the battery", before disconnecting it.
Remove the T40 "1" screws securing the door travel limiter.
Disconnect the multi-pin plug "2" by turning the connecting ring counterclockwise.
Remove the retaining springs from the upper and lower door hinge pins.
Remove the door hinge pins while having an assistant hold the door firmly.
Remove the door.
Installation
Place the door, install the hinge pins and secure them with stoppers.
Secure the door travel limiter.
Connect the multi-pin plug and secure it by turning it to the left.
Attention! As a rule, adjustment of the door position is not required. Only during repair after an accident, if necessary, it is necessary to adjust the position of the hinges.
[This publication was borrowed from the website: FORDBOOK.RU]