Contents: Removal ↳ Installation ↳
Removal
Disconnect the negative (-) cable from the battery.
Warning! This will erase data in electronic memory devices, such as the engine fault memory device or the radio code. Please read the section carefully "Removing and installing the battery", before disconnecting it.
Remove the glove box. To do this, open the box and pull it out to the side of the second driver's seat.
Remove the footwell cover under the glove box by first pressing out the four spring clips with a small screwdriver.
Disconnect the multi-pin connector from the additional resistor.
Carefully press down on the additional resistance.
Installation
Install additional resistance, press and fix. Put on the multi-pin connector.
Install and secure the footwell top cover with four spring clips.
Place the glove box into the holder.
Connect the negative (-) cable to the battery.