Dismantling pipelines and hoses (general instructions) (Mondeo 3)

Caution: The fuel system in injection systems remains under pressure for a long time after the engine is switched off (see pressure relief valve). Therefore, when disconnecting or separating clutches, keep rags around the "action area".

ORDER OF EXECUTION

Disconnect quick-release couplings or screw connections.
If there are any clamps, run a thin screwdriver under the clamps and loosen them by pushing them back and forth from the sides.
Disconnect the hose using a twisting motion. If this doesn't work? Then insert a wrench behind the end of the hose and pry it away from the pipe.
It is best to use screw clamps to connect the hoses and new copper gaskets at the screw flanges.

[The article was taken in its entirety from the specified website: www.fordbook.ru]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article reviewed: Herman Ostrovsky

« Previous articles
Emptying the tank without a fuel pump
Replacing the fuel filter (diesel engine)
Replacing the fuel filter (petrol engine)
Checking the ventilation and airing of the tank
Fuel types and handling

Next articles »
Fuel Pump Troubleshooting
Removing and installing the fuel pump (petrol engine)
Exhaust gas exhaust system
Tips for working with the exhaust system
The question of cost — complete repair or partial replacement