Removing and installing the windshield wiper arm (Mondeo 3)

Front windshield wiper

ORDER OF EXECUTION

Mark the original parking position of the windshield wiper blade on the glass using adhesive tape. Lift the caps above the wiper arm shaft using a small screwdriver and fold upwards.
Loosen the mounting nut approximately two turns using a spanner.
Place the wiper arm and rock it sideways back and forth to release it from the wiper shaft cone. Firmly seated arms should be carefully pressed away from the wiper shaft using two slotted screwdrivers. Place a rag under the mount to avoid damaging the paintwork.
Fold back the lever and completely unscrew the nut.
Disconnect the lever together with the lining washer from the shaft.
When installing, align the wiper arm so that it matches its marking on the glass. After installation, check that it moves correctly. The brushes should not be confused with each other or protrude beyond the glass surface.

ORDER OF EXECUTION

Mark the resting position of the wiper blade on the glass using adhesive tape.
Flip the caps up and loosen the retaining nut about two turns using a ring spanner.
Place the wiper arm and - to release it from the cone of the wiper shaft - rock it sideways back and forth and press it. Carefully press the firmly seated arm away from the wiper shaft using two slotted screwdrivers. To avoid damaging the varnish, place a rag under the mount.
Fold back the lever and completely unscrew the nut.
Disconnect the lever together with the lining washer from the shaft.
When installing, set the wiper arm to the position marked on the glass.

Article reviewed: Herman Ostrovsky

« Previous articles
Installation and removal of the windshield washer nozzle
Installing a Windshield Washer Nozzle
Replacing the wiper blade rubber
Filling the windshield washer with water
Checking the windshield wiper and washer

Next articles »
Removing and installing the front windshield wiper motor
Removing and installing the rear wiper motor