Contents: 1. Damage to the lamp or fuse ↳ 2. Unclosed door(s) or luggage… ↳ 3. Low coolant level indicator light ↳ 4,a Ice hazard warning light ↳ 4,b High-risk ice warning lamp ↳ 5. Windscreen washer fluid low level… ↳ 6. Service interval indicator light ↳ 7. Reset button for service interval… ↳ 8. Brake pad wear indicator light ↳
See position 17 in Paragraph 2.
The graphic display operates when the ignition is on. It monitors the status of the brake lights, side lights, low beam headlights and tail lights. The module determines the outside temperature, door and luggage compartment closure. It usually takes about 5 seconds to check all functions.
If no defects are detected, the symbols do not light up.
To turn off the brake light symbols, press the brake pedal once.
1. Damage to the lamp or fuse
If the lamp or fuse is damaged, the symbols for the side lights, tail lights and brake lights will light up.
2. Unclosed door(s) or luggage compartment
If a door(s) or luggage compartment is not completely closed, a corresponding symbol lights up on the graphic display.
3. Low coolant level indicator light
This lamp lights up when the amount of coolant is insufficient. You need to immediately fill it up to the MAX mark.
Warning: Never open the cap when the engine is hot!
4,a Ice hazard warning light
The warning symbol lights up orange when the outside temperature is between approximately +4 and +1C. The outside temperature can also be determined on the on-board computer display by pressing the appropriate button.
4,b High-risk ice warning lamp
The warning symbol lights up red when the outside temperature has dropped below freezing and there is a high risk of icy roads.
Warning: It should be remembered that even if the temperature is above +4C, this does not mean that there is no ice on the road.
5. Windscreen washer fluid low level indicator light
The light comes on when there is less than 1/4 of the fluid left in the washer reservoir. Fill the fluid up to the MAX mark.
6. Service interval indicator light
The lamp lights up when it is time for service. After passing the inspection at the Service Center, it is switched off. The switch is in the glove compartment.
7. Reset button for service interval indicator lamp
To reinstall, turn on the ignition and hold down the button for about 4 seconds.
8. Brake pad wear indicator light
The light comes on when the front or rear disc brake pads are worn out and should be replaced.