Elements of the engine lubrication system
1 – oil pump; 2 – gasket; 3 – oil indicator tube; 4 – oil pressure sensor; 5 – oil filter; 6 – oil gauge with indicator; 7 – oil indicator; 8 – oil drain plug; 9 – gaskets; 10 – oil pan; 11 – oil receiver; 12 – gasket
1. Remove the ground wire from the battery.
2. Drain the oil from the engine.
3. Unscrew the mounting bolts and remove the starter.
4. Unscrew the 2 bolts securing the clutch protective cover and remove it.
5. Unscrew the timing belt cover mounting bolts.
6. Loosen the oil pan mounting bolts and remove the pan, gaskets and front (A) and rear (B) sealing pads.
7. Thoroughly clean the mating surfaces, install the front and rear sealing pads in the grooves and glue the gaskets with grease, the ends of which should be located on the sealing pads.
8. Carefully install the oil pan, insert the mounting bolts and tighten them to the specified torque in two stages.
9. Screw on the timing belt cover mounting bolts.
10. Screw on the clutch cover.
11. Install the starter.
12. Fill the engine with oil.
13. Connect the ground wire to the battery.
(The article was taken in its entirety from the specified website: «fordbook.ru»)