Contents: Removal ↳ Installation ↳
Removal
Remove the ground cable from the battery.
Raise the front of the car and secure it on stands. Remove the right front wheel.
Remove the auxiliary drive belt.
Loosen the crankshaft pulley bolt. To lock the crankshaft from turning on HCS engines, remove the bolt and remove the clutch housing plate. Secure the starter ring gear to the flywheel using a large screwdriver or similar tool inserted through the hole for the clutch housing plate. On Endura-E engines, remove the starter and secure the ring gear through the hole for the starter.
Completely loosen the crankshaft pulley mounting bolt and remove the pulley from the front end of the crankshaft.
If necessary, replace the front crankshaft oil seal ring.
Installation
Installation is carried out in the reverse order of removal.