Technical specifications (Escort 5)

Engine type - four cylinders with overhead valves

Engine code:

hCS engines:

• models with carburetor - JBD, JBE
• models with CFI fuel injection system, J6A

endura-E engines - J4B

Working volume - 1297 cm³
Cylinder diameter 73.96 mm
Piston stroke 75.48 mm.

Compression ratio
hCS engines:

• models with carburetor - 9.5:1
• models with CFI fuel injection system - 8.8:1

endura-E engines - 9.5:1

Cylinder firing order 1-2-4-3 (cylinder no. 1 on the chain side)

The direction of rotation of the crankshaft is clockwise (when viewed from the right side of the car)

Valves

Valve clearance (cold engine).

• inlet valves - 0.20 mm;
• exhaust valves - 0.30 mm.

Oil pressure:

• at idle speed - 0.60 bar;
• at 2000 rpm - 1.5 bar

Oil pump clearances:

Between the outer rotor and the housing - 0.14-0.26 mm
Between inner and outer rotors - 0.051-0.127 mm
Rotor clearance - 0.025-0.06 mm

Tightening moments

Camshaft thrust plate	11 Nm
Camshaft Sprocket Bolt	28 Nm
Crankshaft pulley bolt	115 Nm
Valve mechanism mounting bolts	43 Nm
Flywheel mounting bolts	67 Nm
Oil pan:
Stage 1	7 Nm
Stage 2	10 Nm
Stage 3 (after engine warm-up)	10 Nm
Oil pressure sensor	14 Nm
Cylinder head bolts (can only be used twice)
Stage 1	30 Nm
Stage 2	turn 90°
Stage 3	turn to an angle of 90*
Chain tensioner	8 Nm
Chain casing	10 Nm
Rear O-ring housing	18 Nm
Head cover mounting bolts	6 Nm
Powertrain suspension:
Right suspension to the cylinder block	120 Nm
Right suspension block to cylinder block	69 Nm
Right suspension lock	69 Nm
Right suspension to the body	84 Nm
Left rear suspension of the installation to the gearbox	50 Nm
Left rear suspension installation	68 Nm
Left front suspension installation	68 Nm
Left suspension mounting clamp	49 Nm

(The original version can be found on the website www.fordbook.ru)