Rear suspension reactive rod
1 – nut; 2 – elastic sleeve; 3 – jet thrust; 4 – washers; 5 – nut; 6 – elastic bushings; 7 – bolt
Attention! Before removing the rear suspension tie rod, it is necessary to accurately mark the location of all washers and bushings, as these elements ensure the correct installation of the rear wheels of the car. When installing, these elements must be installed in the same places from which they were removed.
1. Raise the rear of the vehicle.
2. Unscrew the bolt securing the jet rod to the body.
3. Unscrew the nut from the rear end of the reaction rod, remove the washers, bushings and remove the reaction rod.
4. If necessary, replace the elastic bushing of the reaction rod.
5. The jet thrust is installed in the reverse order of removal.
The original can be found on this resource FordBook