Assembly of drive shafts (Escort 4)

            0

1. Fill the interior of the joint with grease, keeping in mind that a different amount of grease should be applied to each side of the joint.

2. To facilitate installation of the protective cover, lubricate the shaft with a thin layer of grease.

2. To facilitate installation of the protective cover, lubricate the shaft with a thin layer of…


3. Insert the drive shaft with a new retaining ring into the joint splines until the shaft is secured with the retaining ring.

4. Pull the protective cover over the hinge and secure it with a clamp to the hinge body.

4. Pull the protective cover over the hinge and secure it with a clamp to the hinge body.


5. By sliding the flange of the protective cover along the shaft, set the required length of the cover (A) and secure it with a clamp on the shaft.

6. The clamps for fastening the protective cover are first compressed and snapped by hand, and then finally tightened with pliers.

(The original article is posted at: «www.FordBook.ru»)






Link to this page in different formats


Visitor comments

No comments yet



Escort 5 
Escort 4 
Escort 3 
We use cookies to ensure the site works smoothly, remembers your settings, and is convenient for you 🍪