Removal and installation of a tip of steering draft

Steering tip

Withdrawal

1. Loosen the wheel bolts one turn, raise the front of the vehicle and remove the wheel.

2. Unscrew the locknut securing the steering tip to the rod.

3. Remove the cotter pin and unscrew the nut securing the steering tip to the steering knuckle.

4. Using a puller, remove the steering knuckle from the steering knuckle.

5. Unscrew the tie rod end from the tie rod, accurately counting the number of turns of the tie rod end.

Installation

1. Screw the steering tip onto the rod by the same number of turns as when unscrewing the tip.

2. Install the tip into the steering knuckle, screw in the nut and secure it against loosening with a cotter pin. If the cotter pin does not fit into the hole, tighten the nut until the grooves on the nut line up with the hole.

3. Tighten the locknut on the tie rod.

4. Install the wheel and lower the car.