Condition of electrical wires and connectors
A. Check that the high-voltage wires are securely fastened to the spark plugs.
B. Check that the high-tension wire is securely connected to the ignition coil.
C. Check that all electrical connectors on the air flow sensor are securely fastened.
D. Check the condition of the battery terminals.
Wheel replacement
If possible, park the vehicle on a level, horizontal surface, apply the handbrake and engage gear.
Block the wheel located diagonally from the wheel being replaced with a pair of large stones or wheel chocks.
1. Raise the luggage compartment trim and remove the spare tire, tools and jack.
2. Remove the center decorative wheel cap.
3. Loosen the wheel nuts by half a turn each.
4. Place a jack under the vehicle and lift the vehicle. Completely unscrew the wheel mounting bolts.
5. Install the spare wheel and tighten the mounting bolts without tightening them completely.
6. Lower the vehicle and finally tighten the wheel mounting bolts in the specified sequence.
(The original post is on the web portal www.fordbook.ru)