Fig. 3.5. Adjusting the position of the clutch pedal on Escort RS 1600 i vehicles produced since March 1983. The arrows indicate the position of the stopper.
1 - stopper in working position; 2 - the stopper is raised.
In case of insufficient free pedal travel, too high pedal position or "shaking" of the clutch on cars of previous releases, it is necessary to install the adjusting stopper in the following order. Remove the lower trim on the left side and the ignition system unit with the bracket. Use a screwdriver to press the ratchet pawl and press the clutch pedal until it stops. Set the stopper to half its travel and slowly, tooth by tooth, release the pedal to the level of the brake pedal, in this position lower the stopper to set the adjusting mechanism to the working position.
Check and, if necessary, adjust the amount of free travel of the clutch pedal by lifting the stopper again, releasing the pedal up one tooth and lowering the stopper.
[Content was created using data from this website: www.FordBook.ru]