Removal the wheel (Transit 2)

1. Insert the flat end of a wheel lug wrench between the rim and the hubcap and gently twist to remove the hubcap. Some models have plastic covers that need to be removed by hand before using the key.



2. Loosen the wheel nuts half a turn. Raise the car with a jack until the wheel is off the ground (no higher than 3 cm).

3. Loosen and remove the wheel nuts and remove the wheel. Make sure the threads of the wheel nuts remain clean.

Warning! If you intend to work under a raised machine, use additional means or wooden supports. Do not use bricks to support the machine as they may crumble.

Raise the car so that the wheel is about 3 cm above the ground. Never raise the wheel higher, as this may cause the car to slip off the jack. Never lift a vehicle below the axle center.

Use only a car jack. Before lowering the machine, make sure there are no obstructions.

Do not start the engine when the car is raised with a jack.

(Content was created using data from this website: «www.FordBook.ru»)