SEQUENCE OF WORKS
Windscreen cleaner
1. Use a small screwdriver to pry off the protective cap on the lever axis. Use adhesive tape on the glass to mark the initial position of the wipers.
2. Using a spanner, loosen the brush mounting nut two turns.
3. Lift the lever and tilt it left and right with force until it comes off the windshield wiper shaft cone. Carefully pry up firmly seated levers with a screwdriver. Place a rag under the screwdriver to protect the paintwork.
4. Lower the lever and completely unscrew the nut.
Fig. 3.24. Location of protective caps for windshield wiper blade mounting nuts
5. Remove the arm together with the washer from the wiper shaft.
6. Install the arm so that the wiper blade aligns with the mark on the glass. After installation, check the operation of the wiper. The blades should not cross or hit the glass seal.
Rear window cleaner
1. Mark the starting position of the wiper blade on the glass with adhesive tape.
2. Open the protective cap and use an open-end wrench to loosen the brush mounting nut two turns.
3. Lift the lever and tilt it left and right with force until it comes off the windshield wiper shaft cone. Carefully pry up the firmly seated lever with a screwdriver. Place a rag under the screwdriver to protect the paintwork.
4. Lower the lever and completely unscrew the nut.
5. Remove the arm together with the washer from the wiper shaft.
6. Position the arm so that the wiper blade aligns with the mark on the glass.