Contents: Removal ↳ Installation ↳
Removal
1. Remove the wiper arms (see Chapter 12).
2. Unscrew and remove the plastic retaining nut from the wiper arm axle located in the middle of the panel (see Figure 28.2)
Figure 28.2. Remove the plastic retaining nut from the wiper arm axle located in the middle of the panel.
3. If installed, remove the plastic covers, then pull out the plastic retainer and mounting screw from the end pieces of the grille and remove these pieces (see Figure 28.3).
Figure 28.3. Removing the plastic retainer of the windshield grille.
4. Disconnect the remaining fasteners, pull out the grille and disconnect the windshield washer hoses from it (see Figure 28.4).
Figure 28.4. Location of windshield grille fasteners (arrows) and windshield wiper arm pivot point (A).
Installation
5. Installation is carried out in the reverse order of removal. Once completed, check the operation of the windshield washer.