SEQUENCE OF WORKS
1. Disconnect the cable from the negative terminal of the battery.
2. Disconnect the high-voltage wire ends from the ignition unit.
Fig. 9.10. Location of ignition unit mounting bolts
3. Loosen the bolts and remove the ignition unit (Fig. 9.10).
4. Install the new ignition unit and secure with bolts, tightening them to a torque of 6 Nm.
5. Connect the side connector.
6. Connect the high-voltage wire tips to the ignition unit, observing the sequence of engine cylinder operation.
7. Check the fastening of the high-voltage wire tips.