Rear brake disc — check, removal and installation

Examination

See section 4 - the procedure for inspecting the rear brake disc is the same as for the front.

Removal and installation

1. Remove the cylinder (see section 20), but do not disconnect the brake hose

2. Secure the cylinder with wire so that the brake hose is not twisted or kinked.

3. Unscrew the upper and lower bolts securing the caliper to the bracket, disconnect the caliper (see figure 18.2).

4. Unscrew the two inching" nuts and remove the disc from the hub (see figure 18.2).

5. Install in reverse order.